85mm Larger Throttle Body For 2013+ Dodge Challenger R/T SRT HEMI 5.7L 6.1L 6.4L

Description

85MM Larger Throttle Body For 2013+ Dodge Challenger R/T SRT HEMI 5.7L 6.1L 6.4L
It is directly plug in and play on.
It is directly bolted on the stock intake manifold.
The 85mm is the real size through the whole bore.
We do vibrating test, high&low temperature test and life test on them in the lab lacated in CA USA before mass production.
We install the big torque motor inside so it can response quicker under big boost condition.
Improved Power and Throttle Response
Increase throttle response and power output from your Hemi powered 2013-2019 Dodge Ram, Challenger, Charger or 300C with this  Performance 85mm throttle body. The throttle bodies improve throttle response and acceleration. This throttle body will increase airflow to your engine adding more horsepower and torque to the wheels.
Tuning Note:
Our engineers have designed our electronic throttle control performance throttle bodies to work in most cases with a factory tune, however depending on other modifications and ECM sensitivity on your specific application a tune is sometimes recommended, this is true with most other brand aftermarket performance throttle bodies as well. While it's not normally required, a tune will not only allow the vehicle to work with certain aftermarket add on's but will also improve overall performance.
FEATURES:
Large 85mm Throttle Body Bore for Maximum Airflow
Designed and Manufactured In USA
Great Choice for Mildly Modified Engines
FITMENT:
NOTE: This will fit the following with an 85mm throttle body:
2013-2020 Chrysler 300C 5.7 or 6.4 HEMI V8
2013-2020 Dodge Charger 5.7 or 6.4 HEMI V8
2013-2020 Dodge Challenger 5.7 or 6.4 HEMI V8
2013-2020 Dodge Ram Hemi 5.7 or 6.4 HEMI V8
2013-2020 Jeep Grand Cherokee SRT8 6.4 HEMI
How to relearn the throttle body ?
1. Once the TB is installed and the battery is reconnected, the ignition need to be turned to the 'ON' position to light up the dash like a Xmas tree.
2. Once the warning lights come on, you press the gas pedal slowly all the way down till you reach the floor. Count 5 seconds.
3. After you count 5 seconds, slowly depress the gas pedal till its fully released.
4. Turn on the car and that completes the re-learn process.
Follow these instructions carefully to ensure correct fitment and operation:
• Disconnect the negative battery terminal.
• Disconnect the air temperature sensor plug and  the throttle body control motor plug.
• Loosen the clamps on the air intake tube and air box, and then remove the tube.
• Remove the four bolts that secure the throttle  body to the intake manifold.
• Remove the stock throttle body. The stock Oring  seal will be re-used. Be sure to wipe off and
debris from the gasket.
• Bolt on this Enlarged Throttle Body using the stock  hardware. On the 5.7L Hemi Plastic manifolds,
take extra care when re-installing the mounting bolts.
• Re-install the air inlet tube to the Throttle Body and air box and then tighten the clamps.
• Re-connect the air temperature sensor and the throttle body control motor plug. Re-connect the negative battery terminal and refer to the instruction sheet for throttle relearn procedure.