Ham Radio DIGITAL Repeater 440MHz 70cm Motorola VRM DMR/DSTAR/P25/FUSION

Description

This listing is for a complete DIGITAL repeater for the 70cm amateur radio band. All major modes including DMR, DSTAR, FUSION and P25 work and frequencies anywhere between 440-450MHz are valid.
You will need 12 volts and either two antennas or a duplexer to use this as a repeater. You will also need a GOOD 2.5 AMP Micro USB power supply.
This node utilizes the top of the line Motorola VRM DATA transceiver.
Please send me your info and frequencies you want to w0sky981 at gmail or through the eBay messaging.
For me to construct and configure it may take up to 7 business days to ship out the node but likely shorter.
The frequency, Digital mode
configuration is included for free.
To setup,
1. Connect Raspberry pi to internet connection ( Preferably ethernet )
2. Power on node
3. Go to the frequency with your 70cm digital mobile or portable radio, and enjoy worldwide connections. If you put a good antenna on the node at a good location, the range can exceed 10 miles, and you will make use out of a very quiet radio band.
An instruction sheet will be included.
INCLUDES:
Tested Motorola VRM Radios. These are good 440-450Mhz.
Raspberry pi running PiStar software with micro SD card
Motorola Power cable pigtails
Mini UHF to SO-239 so you can plug in a PL259 based antenna.
Please s3’d programming info shortly after you pay, so I know what to put in your radio.
Each Radio is individually tested and in spec to:
TX Power: 10 to 20 WATTS (Can go to 45 watts but will overheat for long winded conversation overheating)
RX Sensitivity: -122dBm Squelch
Frequency Error: <0.05KHz
w0sky981 at gmail